How to install and use the cameras?
2015-07-07

Using a standard Ethernet network cable, connect the camera to your network (depending on your own setup, this may be to your router or switch). see figure below

Connect the included power adapter to the power port on the camera and the other end into an electrical socket. see figure below

Check that the power indicator is lit on the front of the camera.

Note:

Please handle the power adapter carefully to avoid the risk of accidental electric shock


Rear view of camera

The camera Setup utility can easily and quickly detect cameras connected to your local network and list them on the Camera Setup window, also you can use the camera Setup utility to assign an IP address to each camera.

1. Insert the Installation CD into your CD-ROM drive and the installation screen should appear automatically (See image below). If it does not, click “Start” then “Run”. In the text field enter “D:\autorun.exe” (if “D:” is the letter of your CD-ROM Drive) 


2. Click on “Install Software” and the following screen will be displayed.


3. If you want to change the default folder click “Change” to replace otherwise click “Next”


4. Click Install to install Camera Setup. 


 5. Click Finish to end the installation. You should now find a icon  on the desktop. 


 6. Double-click the Camera Setup icon on the Desktop to launch the program. The Camera Setup utility should automatically find your camera if is correctly connected (See image below). 


[Refresh] Click Refresh to search for cameras on the local network.

[Setup] Select the required camera and click Setup to configure the network settings for the camera.

[Open] Select the required camera and click Open to access the camera via a web browser.

[Exit] Click Exit to exit the Camera Setup window.

Note:

Select and double click one of the cameras from the Device list, to open the camera view via the web browser.


About Us
Contact Us